SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 556)

Command Line Interface
4-248
4
lldp
This command enables LLDP globally on the switch. Use the no form to disable
LLDP.
Syntax
[no] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
lldp holdtime-multiplier
This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Use the no form to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on
(holdtime-multiplier * refresh-interval)
≤ 65536
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
lldp medtlv
location
Configures an LLDP-MED-enabled port to advertise its
location identification details
IC 4-262
lldp medtlv
med-cap
Configures an LLDP-MED-enabled port to advertise its
Media Endpoint Device capabilities
IC 4-262
lldp medtlv
network-policy
Configures an LLDP-MED-enabled port to advertise its
network policy configuration
IC 4-263
show lldp config Shows LLDP configuration settings for all ports PE 4-263
show lldp info
local-device
Shows LLDP global and interface-specific configuration
settings for this device
PE 4-265
show lldp info
remote-device
Shows LLDP global and interface-specific configuration
settings for remote devices
PE 4-266
show lldp info
statistics
Shows statistical counters for all LLDP-enabled interfaces PE 4-267
Console(config)#lldp
Console(config)#
Table 4-69 LLDP Commands (Continued)
Command Function Mode Page