SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 434)

Command Line Interface
4-126
4
Command Usage
• The VLAN to be used as the guest VLAN must be defined and set as active
(“vlan database” on page 4-224).
• When used with 802.1x authentication, the intrusion-action configuration
must be set for ‘guest-vlan’ to be effective (“dot1x intrusion-action” on
page 4-117).
Example
network-access link-detection
Use this command to enable the link detection feature. Use the no form of this
command to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
network-access link-detection link-down
Use this command to configure the link detection feature to detect and link down
events. When a link down event is detected, the feature can shut down the port,
send an SNMP trap, or both. Use the no form of this command to disable this
feature.
Syntax
network-access link-detection link-down action [shutdown | trap |
trap-and-shutdown]
no network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#