SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 554)

Command Line Interface
4-246
4
show protocol-vlan protocol-group-vid
This command shows the mapping from protocol groups to VLANs.
Syntax
show protocol-vlan protocol-group-vid
Default Setting
The mapping for all protocol groups is displayed.
Command Mode
Privileged Exec
Example
This shows that traffic matching the specifications for protocol group 2 will be
mapped to VLAN 2:
LLDP Commands
Link Layer Discovery Protocol (LLDP) is used to discover basic information about
neighboring devices on the local broadcast domain. LLDP is a Layer 2 protocol that
uses periodic broadcasts to advertise information about the sending device.
Advertised information is represented in Type Length Value (TLV) format according
to the IEEE 802.1ab standard, and can include details such as device identification,
capabilities and configuration settings. LLDP also defines how to store and maintain
information gathered about the neighboring network nodes it discovers.
Link Layer Discovery Protocol - Media Endpoint Discovery (LLDP-MED) is an
extension of LLDP intended for managing endpoint devices such as Voice over IP
phones and network switches. The LLDP-MED TLVs advertise information such as
network policy, power, inventory, and device location details. The LLDP and
LLDP-MED information can be used by SNMP applications to simplify
troubleshooting, enhance network management, and maintain an accurate network
topology.
Console#show protocol-vlan protocol-group-vid
ProtocolGroup ID VLAN ID
------------------ -----------
2 VLAN2
Console#
Table 4-69 LLDP Commands
Command Function Mode Page
lldp Enables LLDP globally on the switch GC 4-248
lldp holdtime-multiplier Configures the time-to-live (TTL) value sent in LLDP
advertisements
GC 4-248
medFastStartCount Configures how many medFastStart packets are transmitted GC 4-249
lldp notification-interval Configures the allowed interval for sending SNMP
notifications about LLDP changes
GC 4-249