SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 232)

Configuring the Switch
3-180
3
Adding an Interface to a QinQ Tunnel
Follow the guidelines in the preceding section to set up a QinQ tunnel on the switch.
Use the VLAN Port Configuration or VLAN Trunk Configuration screen to set the
access port on the edge switch to 802.1Q Tunnel mode.
Command Usage
Use the 802.1Q Tunnel Status screen to set the switch to QinQ mode before
configuring a tunnel port (see “Enabling QinQ Tunneling on the Switch” on page
3-178).
Command Attributes
Mode – Set the VLAN membership mode of the port. (Default: None)
• None – The port operates in its normal VLAN mode.
• 802.1Q Tunnel – Configures IEEE 802.1Q tunneling (QinQ) for a client access port
to segregate and preserve customer VLAN IDs for traffic crossing the service
provider network.
• 802.1Q Tunnel Uplink – Configures IEEE 802.1Q tunneling (QinQ) for an uplink
port to another device within the service provider network.
Web – Click VLAN, 802.1Q VLAN, 802.1Q Tunnel Configuration or Tunnel Trunk
Configuration. Set the mode for a tunnel access port to 802.1Q Tunnel and a tunnel
uplink port to 802.1Q Tunnel Uplink. Click Apply.
Figure 3-106 Tunnel Port Configuration