SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 252)

Configuring the Switch
3-200
3
Command Attributes
• Default Priority 13 – The priority that is assigned to untagged frames received on
the specified interface. (Range: 0-7; Default: 0)
• Number of Egress Traffic Classes – The number of queue buffers provided for
each port.
Web – Click Priority, Default Port Priority or Default Trunk Priority. Modify the default
priority for any interface, then click Apply.
Figure 3-121 Port Priority Configuration
CLI – This example assigns a default priority of 5 to port 3.
13. CLI displays this information as “Priority for untagged traffic.”
Console(config)#interface ethernet 1/3 4-166
Console(config-if)#switchport priority default 5 4-269
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
4-175
Information of Eth 1/3
Broadcast threshold: Enabled, 500 packets/second
LACP status: Disabled
Ingress rate limit: enable, K bits per second: 25
VLAN membership mode: Hybrid
Ingress rule: Enabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 5
GVRP status: Disabled
Allowed VLAN: 1(u),
Forbidden VLAN:
Private-VLAN mode: NONE
Private-VLAN host-association: NONE
Private-VLAN mapping: NONE
Console#