SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 542)

Command Line Interface
4-234
4
dot1q-tunnel system-tunnel-control
This command sets the switch to operate in QinQ mode. Use the no form to disable
QinQ operating mode.
Syntax
[no] dot1q-tunnel system-tunnel-control
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
QinQ tunnel mode must be enabled on the switch for QinQ interface settings
to be functional.
Example
Related Commands
show dot1q-tunnel (4-236)
show interfaces switchport (4-175)
switchport dot1q-tunnel mode
This command configures an interface as a QinQ tunnel port. Use the no form to
disable QinQ on the interface.
Syntax
switchport dot1q-tunnel mode <access | uplink>
no switchport dot1q-tunnel mode
• access – Sets the port as an 802.1Q tunnel access port.
• uplink – Sets the port as an 802.1Q tunnel uplink port.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Use the dot1q-tunnel system-tunnel-control command to set the switch to
QinQ mode before entering this command.
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#