SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 501)

Power over Ethernet Commands
4-193
4
Example
power inline priority
This command sets the power priority for specific ports. Use the no form to restore
the default setting.
Syntax
power inline priority priority
no power inline priority
priority - The power priority for the port.
Options: 1 (critical), 2 (high), or 3 (low)
Default Setting
3 (low)
Command Mode
Interface Configuration
Command Usage
• If the power demand from devices connected to the switch exceeds the power
budget setting, the switch uses port power priority settings to control the
supplied power. For example:
- A device connected to a low-priority port that causes the switch to exceed
its budget is not supplied power.
- A device connected to a critical or high-priority port that causes the switch
to exceed its budget is supplied power, but the switch drops power to one
or more lower-priority ports.
• Power is dropped from low-priority ports in sequence starting from port
number 1.
Example
Related Commands
power mainpower maximum allocation (4-190)
Console(config)#interface ethernet 1/1
Console(config-if)#power inline maximum allocation 8000
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#power inline priority 2
Console(config-if)#