SMC Networks SMC Tiger 10/100 SMC6128PL2 - Manual (Page 513)

Spanning Tree Commands
4-205
4
Command Usage
The path cost method is used to determine the best path between devices.
Therefore, lower values should be assigned to ports attached to faster media,
and higher values assigned to ports with slower media. Note that path cost
(page 4-209) takes precedence over port priority (page 4-210).
Example
spanning-tree transmission-limit
This command configures the minimum interval between the transmission of
consecutive RSTP/MSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
Default Setting
3
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
spanning-tree mst-configuration
This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
• No VLANs are mapped to any MST instance.
• The region name is set the switch’s MAC address.
Command Mode
Global Configuration
Example
Console(config)#spanning-tree pathcost method long
Console(config)#
Console(config)#spanning-tree transmission-limit 4
Console(config)#
Console(config)#spanning-tree mst configuration
Console(config-mstp)#