14 wiring the front connector, crimping – Siemens Automation System S7-400 User Manual

Page 84

Wiring the S7-400

4-24

Automation System S7-400 Hardware and Installation

A5E00850741-01

4.14

Wiring the Front Connector, Crimping

Procedure

To wire the prepared front connector:

1. Strip the conductors at a length of approx. 5 mm.
2. Crimp the contacts onto the conductors. A crimptool is aailable on order as an

accessory for your signal modules.

3. Insert the crimp contacts into the recesses of the front connector, starting at the

bottom.
The order number for crimp contacts is found in Appendix C of the

Reference

Manual

Figure 4-13 Wiring a Front Connector with Crimp Terminals