Intel IXF1104 - Manual (Page 123)

Intel
®
IXF1104 4-Port Gigabit Ethernet Media Access Controller
123 Datasheet
Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005
5.10 TAP Interface (JTAG)
The IXF1104 MAC includes an IEEE 1149.1 compliant Test Access Port (TAP) interface used
during boundary scan testing. The interface consists of the following five signals:
• TDI – Serial Data Input
• TMS – Test Mode Select
• TCLK – TAP Clock
• TRST_L – Active Low asynchronous reset for the TAP
• TDO – Serial Data Output
TDI and TMS require external pull-up resistors to float the signals High per the IEEE 1149.1
specification. Pull-ups are recommended on TCK and TDO. For normal operation, TRST_L can be
pulled Low, permanently disabling the JTAG interface. If the JTAG interface is used, the TAP
controller must be reset as described in
Section 5.10.1, “TAP State Machine” on page 123 and
returned to a logic High.
5.10.1 TAP State Machine
The TAP signals drive a TAP controller, which implements the 16-state state machine specified by
the IEEE 1149.1 specification. Following power-up, the TAP controller must be reset by one of
following two mechanisms:
• Asynchronous reset
• Synchronous reset
Asynchronous reset is achieved by pulsing or holding TRST_L Low. Synchronous reset is
achieved by clocking TCLK with five clock pulses while TMS is held or floats High. This ensures
that the boundary scan cells do not block the pin to core connections in the IXF1104 MAC.
Table 37. Byte Swapper Behavior
UPX_BADD
[1:0]
Little Endian Big Endian
32-bit 16-bit 8-bit 1 32-bit 16-bit 8-bit 1
UPX_DATA_
[31:0]
UPX_DATA_
[15:0]
UPX_DATA
[7:0]
UPX_DATA
[31:0]
UPX_DATA
[15:0]
UPX_DATA
[7:0]
00 [31:0] [15:0] [7:0]
[7:0]
[15:8]
[23:16
[31:24]
[7:0]
[15:8]
[7:0]
01 – – [15:8] – – [15:8]
10 – [31:16] [23:16] –
[23:16]
[31:24]
[23:16]
11 – – [31:24] – – [31:24]
1. In 8-bit mode, data is output in Little Endian format regardless of the IXF1104 MAC Endian setting.