IBM 1725 SLS - Manual (Page 289)

FCC
Compliance
E-3 Notices
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
1 Reorient or relocate the receiving antenna.
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
4 Consult the dealer or an experienced radio/TV technician for
help.
» Note: A shielded cable is required to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules.
O Caution: Any modifications or changes to this product not expressly
approved in writing by the manufacturer responsible for compliance to
Federal Regulations could void the user's authority to operate this product
within the Laws and Regulations of the Federal Communications
Commission.
M WARNING! To prevent electrical shock, do not remove any covers from your
printer unless you are experienced in working with circuit boards and are
following instructions for procedures described in QMS documentation.
ACHTUNG! Um elektrische Kurtzschlüsse zu vermeiden, entfernen Sie keine
Gehaüseteile von Ihrem Drucker, wenn Sie keine Erfahrungen im Umgang mit
elektrischen Bauteilen haben. Befolgen Sie die in der QMS Dokumentation
beschriebenen Hinweise.