IBM 1725 SLS - Manual (Page 199)

Font and
Emulation
Cards
8-15 Printer Options
After the option is removed, remove the card from the slot and place
the printer back on line.
Installing Optional Emulation Cards
Use the Install Option selection from the Disk Operations menu.
Refer to the instructions earlier in this for help using the printer control
panel. To install an optional emulation, use this procedure:
1 Make sure the printer is on and idle. From the Administration
menu, select the Disk Operations submenu.
2 Press the Next key until
INSTALL OPTION
displays.
3 Press the Select key.
Then press the Next key until the destination of the optional emu-
lation displays in the message window.
4 Press the Select key.
Then press the Next key until the source of the optional emulation
displays in the message window.
5 Press the Select key.
You are prompted to insert the emulation card into the card slot.
6 The hard disk then copies the contents of the card. When all
of the contents are copied, press the Menu key to exit the
menu. Press the Online/Offline key to allow the printer to
receive data from the host.
Removing a Printer Emulation
Use the Remove Option menu selection if you need to remove an
installed option from the hard drive. To remove an emulation, you
need the original emulation card containing the emulation files. The
Remove Option selection in the Disk Operations submenu compares
the contents of the emulation card with the contents of the hard drive.
The matching files are then deleted from the hard drive. To remove a
printer emulation, follow this procedure: