IBM 1725 SLS - Manual (Page 229)

Updating
System
Software
8-45 Printer Options
2 Once this message appears, you have 10 seconds to press
the Select key. When you press the Select key, the following
message appears in the message window:
QMS SOFTLOAD X.X
BOOT SYSTEM
» Note: If 10 seconds pass before you press the Select key, the
INITIALIZING
message appears. You must return to step 1.
3 Press the Next key until
Install to Disk
appears on the
second line of the message window:
QMS SOFTLOAD X.X
INSTALL TO DISK
4 Press the Select key to enter the Install to Disk submenu.
5 Press the Next key until the following message appears in
the message window:
INSTALL TO DISK
PARALLEL
6 Press the Select key to load the software from the system
disks. The following message appears in the message win-
dow:
INSTALL TO DISK
TARGET DISK 6
7 Disk 6 is the printer’s internal hard disk. Press the Select
key. The following message displays:
INSTALL TO DISK
CONNECTING.....
8 Go to your host system and make sure the parallel cable is
connected from the PC to the printer’s parallel port. Then
send the SYSTEM.DL file to the printer. To do this, from the
directory that the SYSTEM.DL file was installed, type:
copy /b system.dl lpt1: