Duplexer assembly, Installing the duplexer assembly – IBM 1725 SLS User Manual
Page 191
Duplexer
Assembly
8-7
Printer Options
11 Configure your printer for envelope printing through the
control panel.
a Use the Manual Feed Size option (Operator Control/Manual
Feed Size) to select the envelope size.
b Select the output bin (Operator Control/Outputbin).
See chapter 2, Printer Configuration, in this guide for control
panel instructions.
Youre now ready to print envelopes.
Duplexer Assembly
The optional duplexing unit allows you to print on both sides of a
sheet of paper using either manual feed or automatic feed from a
paper cassette. Additional memory is required for duplexing at 600
dpi resolution on legal-size media. The following chart represents the
minimum amount of memory needed to print various paper sizes at
300 or 600 dpi resolution. In most cases, the minimum amount of
memory does not allow the printer to run at rated speed. The
amounts shown assume the Page Recovery function (Administration/
Engine/Page Recovery) is turned on.
Installing the Duplexer Assembly
A Phillips screwdriver is needed for this procedure. To install the
duplexer assembly
300 dpi
600 dpi
Paper Size
Simplex
Duplex
Simplex
Duplex
Letter
8MB
8MB
8MB
12MB
Legal
8MB
8MB
12MB
16MB
A4
8MB
8MB
8MB
12MB
Executive
8MB
8MB
8MB
12MB