IBM 1725 SLS - Manual (Page 100)

Hard Disks
QMS 1725 SLS Print System User's Guide 2-66
» Note: You may need to press the Next key one or more times to advance
through the list of selections or options.
» Note: After an unformatted disk is formatted and the
FORMAT
COMPLETE
message displays, you must turn the printer off and back on
again before the printer can recognize the disk.
Collation
This option is used to specify which disk and how much of that disk
should be used to store collated print jobs when the jobs cannot be
accommodated by RAM space. The printer scrolls through all the
installed hard disk addresses. Refer to “Collating Output,” in chapter
3, “Daily Operations,” for more information.
Spool Overflow
This option is used to specify which disk and how much of that disk
should be used to store print jobs when the jobs can not be accom-
modated by RAM. The maximum setting varies according to the disk
size installed in the printer.
Use this
key to... The message window
reads...
Select Access the Administration/Disk
Operations/Format Disk menu. DISK OPERATIONS
FORMAT DISK
Select Access the Format Disk/Dsk#: menu. FORMAT DISK
DSK#: x
Next Scroll through the list of attached disks. FORMAT DISK
DSK: x
Select Select the disk and display a format
confirmation message. FORMAT DISK
ARE YOU SURE?
Select Begin the formatting process. The hard
disk is formatted while the system
reboots. FORMAT DISK
FORMATTING...
You are informed when the formatting
process is complete. The printer then
reboots, and a start-up page prints (if
enabled). FORMAT DISK
FORMAT COMPLETE