IBM 1725 SLS - Manual (Page 267)

Updated DOCs
C-17 Document Option Commands
Set Lines Per Inch Command
Set Point Size Command
Format Boolean
Notes The result of various settings for these parameters is
shown in the table included in the Set Carriage
Return (Line Termination) discussion, in terms of the
equivalent code passed to the PCL line termination
command. The second setting (lfiscrlf on, criscrlf off)
is correct for most ASCII listings printed from UNIX
machines. PC listings should usually be done with
both items set to Off, and Macintosh listings usually
require the third setting (lfiscrlf Off, criscrlf On). Note
that the FF becomes a CR-FF when the LF is a CR-
LF.
Syntax %%IncludeFeature:linesperinch (# x 100)
Purpose Sets the default PCL line spacing.
Notes The %%IncludeFeature:linesperinch DOC affects PCL’s
default VMI (vertical motion index).
Variable #
Purpose Specifies the default number of lines per inch.
Range 100-4800 (1-48 lines per inch x 100)
Default 600 (6 lines per inch x 100)
Format Integer
Syntax %%IncludeFeature:pointsize (default font size)
Purpose Specifies the point size for scalable default font.
Notes If the selected font is not scalable or if a bitmap font size is
specified, this setting is ignored.
Variable default font size