IBM 1725 SLS - Manual (Page 195)

Font and
Emulation
Cards
8-11 Printer Options
11 Replace the duplexing slot-cover, and reinstall the two
screws that were holding it in place.
12 Replace the paper cassettes.
»
Note: Do not attempt to use the duplexer for envelopes, labels, or
transparencies.
13 Plug in the power cord, turn both power switches on, and
check the control panel to make sure the printer is ready to
print.
The message window should read
IDLE
.
Font and Emulation Cards
The two slots on the front, right side of the printer, below the bottom
paper tray, may be used to expand the font and/or emulation capabili-
ties of your printer. Both slots accept optional font, emulation, and
security cards. Optional emulations may require additional RAM to
operate properly. Contact your QMS vendor for font and emulation
availability for your printer.
The printer supports up to two cards at once. Follow these steps to
install a card:
1 If you are using an HP ProCollection font card, turn off the
printer.