IBM 1725 SLS - Manual (Page 110)

Face-up Output
Bin
QMS 1725 SLS Print System User's Guide 3-8
Face-up Output Bin
After being printed, paper normally stacks face down in the recessed
area on the top of the printer. The face-down output bin holds up to
500 sheets of paper. For face-up output, you must attach the face-up
output bin to the rear of the printer and configure the printer to access
this bin. This output bin holds up to 50 sheets of paper. Use the fol-
lowing instructions to attach the face-up output bin:
1 Insert the two end tabs of the face-up output bin into the slot
on the back of the printer.
2 Allow the extended part of the bin to lean back into its nor-
mal position.
Printing Transparencies
You can also print transparencies for overhead projectors. Use only
transparencies recommended for laser printers, such as Canon brand
type D and 3M type PP2500. Always use manual feed from either the
upper or lower cassette, and the face-up output bin at the back of the
printer. Remove each transparency from the face-up bin after printing
1
2