FUJITSU ServerView Respurce Orchestrator Virtual Edition V3.1.0 - Manual (Page 216)

slot_no
Enter the slot number where the LAN switch blade is installed. Enter a number between 1 and 8.
switch_name
Enter the name to assign to this LAN switch blade.
Enter a string of up to 15 alphanumeric characters, underscores ("_"), and hyphens ("-").
Note
LAN switch blade names should be unique between all LAN switch blades. The names are case-sensitive.
ip_address
Enter the same IP address as that set on the LAN switch blade.
Enter a string of numeric values (between 0 and 255) and periods.
Note
IP addresses should be unique between all resources.
snmp_community_name
Enter the same SNMP community (read-only permission) as that set on the LAN switch blade.
Enter a string of up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
user_name
Enter the name of the user account used to remotely log into the LAN switch blade.
For a LAN switch blade PY CB DCB SW 10Gb 18/6/6, enter the name of the administrator account for the LAN switch blade.
Enter up to 64 characters, including alphanumeric characters (upper or lower case), underscores ("_"), or hyphens ("-").
passwd
Enter the password of the above user account (for remote login).
Enter a string of up to 80 alphanumeric characters and symbols (ASCII character codes: 0x20, 0x21 or 0x23 to 0x7e) and no
double-quotations ("). Passwords entered in this field are seen as plain text passwords.
passwd_enc
Enter one of the following.
- If passwd is plain text
"plain"
- If the password is encrypted
"encrypted"
privileged_passwd
Enter the admin password of the above user account.
Enter a string of up to 80 alphanumeric characters and symbols (ASCII character codes: 0x20, 0x21 or 0x23 to 0x7e) and no
double-quotations ("). Passwords entered in this field are seen as plain text passwords.
privileged_passwd_enc
Enter one of the following.
- If privileged_passwd is plain text
"plain"
- If the password is encrypted
"encrypted"
- 201 -