FUJITSU ServerView Respurce Orchestrator Virtual Edition V3.1.0 - Manual (Page 196)

Group
The names of the port groups set on the LAN switch ports connected to each network interface (for LAN switch blades operating
in IBP mode) are displayed.
Only "-" is displayed under the following conditions.
- The corresponding LAN switch is not registered
- The corresponding LAN switch is not operating in IBP mode
- The corresponding LAN switch port has not been assigned to a port group
Monitoring Information
Timeout(sec)
The time-out value (in seconds) for ping monitoring is displayed.
Recovery method
The recovery performed when an error is detected is displayed.
Number of reboots
The number of times reboot is performed during recovery is displayed.
WWN Settings Area
The following information is not displayed for VM guests or servers other than SPARC Servers/SPARC Enterprise.
WWPN of port n (n:1-8)
The WWPN value of the port n is displayed.
Values set by users are reflected on WWPN.
Target CA WWPN
The WWPN for the CA connected to the port n is displayed.
Target CA AffinityGroup
The AffinityGroup for the CA connected to the port n is displayed.
Automatic Network Configuration
The following information is displayed when the VM host is a target of network auto configuration and only when automatic network
configuration has been performed.
Network resource name
The network resource name for which automatic network configuration is performed is displayed.
VLAN ID
The VLAN ID configured for the network resource is displayed.
Subnet Address
The subnet address configured for the network resource is displayed.
When it is not configured, "-" is displayed.
Subnet Mask
The subnet mask configured for the network resource is displayed.
When it is not configured, "-" is displayed.
- 181 -