FUJITSU ServerView Respurce Orchestrator Virtual Edition V3.1.0 - Manual (Page 141)

A cloning image can be collected only from a managed server on which an agent has been registered.
For details on registering agents, refer to "Chapter 7 Installing Software and Registering Agents on Managed Servers" in the "Setup Guide
VE".
A cloning image can be collected from a managed server that satisfies the following conditions:
- The status is either "normal" or "warning"
- Has been placed into maintenance mode
Cloning images cannot be collected from VM hosts or VM guests.
Preparations
- Install the desired operating system and necessary applications on the managed server from which a cloning image will be collected.
Additionally, apply any required patches and other necessary settings.
Make sure that the source server operates properly after those steps.
- When the configurations of managed servers are as below, execute the following commands before collecting cloning images.
- In a SAN data environment using a built-in disk boot, and a physical WWN or VIOM
[Windows Manager]
> Installation_folder \SVROR\Manager\bin\rcxadm server set -name physical server -attr bootagt=dos
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name physical server -attr bootagt=dos
- When using the Red Hat Enterprise Linux 6 ext4 file system, and one of the following conditions is met
- In a SAN boot environment using HBA address rename
- When using a rack mount or tower server and the server is registered with "Disable" of "Association with server management
software (ServerView)" is selected
[Windows Manager]
> Installation_folder \SVROR\Manager\bin\rcxadm server set -name physical server -attr bootagt=winpe
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name physical server -attr bootagt=winpe
- In a SAN boot environment using HBA address rename, and the following model
- PRIMERGY BX960 S1
[Windows Manager]
> Installation_folder \SVROR\Manager\bin\rcxadm server set -name physical server -attr bootagt=winpe
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name physical server -attr bootagt=winpe
- Check whether the DHCP client is enabled on the managed server to collect the cloning image from.
- Cloning images with the same name can be saved up until the maximum number of image versions.
When collecting a new cloning image when the maximum number of image versions has already been reached, select the cloning
image to delete.
- 126 -