FUJITSU ServerView Respurce Orchestrator Virtual Edition V3.1.0 - Manual (Page 195)

Server switchover method
The method used to perform server switchover is displayed.
Server boot method
The boot type of the system disk is displayed.
Automatic server recovery
Shows whether automatic server recovery is enabled or not.
Network switchover
Shows whether network settings will be automatically adjusted during server switchover.
Force spare server to power off during switchover
The setting whether the spare server is turned off forcibly when switching over to the spare server is displayed.
Switch over to spare server running VM guests
The setting whether the server is switched to a VM host on which a VM guest exists is displayed.
Spare server
Displays the name of the physical server that will replace the current active server when server switchover occurs.
HBA Address Rename Settings Area
The following information is not displayed for VM guests or SPARC Servers/SPARC Enterprise.
WWNN
The WWNN set on the HBA is displayed.
WWPN 1
The first WWPN set on the HBA is displayed.
The WWPN should be set to the I/O address of each HBA (in descending order).
Therefore, for rack mount or tower servers, the order may not correspond with port number order described for the HBA.
WWPN 2
The second WWPN set on the HBA is displayed.
The WWPN should be set to the I/O address of each HBA (in descending order).
Therefore, for rack mount or tower servers, the order may not correspond with port number order described for the HBA.
Network Properties Area (VLAN)
The following information is not displayed for VM guests.
Index
The mounted position (index) of each network interface on the server is displayed.
Port VLAN
The port VLAN IDs set on the LAN switch ports connected to each network interface are displayed.
When connected to a PRIMERGY BX900/BX400 LAN switch blade operating in IBP mode, "(IBP)" is displayed.
Tagged VLAN
The tagged VLAN IDs set on the LAN switch ports connected to each network interface are displayed.
When connected to a PRIMERGY BX900/BX400 LAN switch blade operating in IBP mode, "(IBP)" is displayed.
Port Groups Area (IBP)
NIC Index
The mounted position (index) of each network interface on the server is displayed.
- 180 -