FUJITSU SPARC T5120 - Manual (Page 99)

Servicing Hard Drives 73
FIGURE: Locating the Hard Drive Release Button and Latch
Caution – The latch is not an ejector. Do not bend the latch too far to the right.
Doing so can damage the latch
5. Grasp the latch and pull the drive out of the drive slot.
Related Information
■ “Install a Hard Drive” on page 73
■ “Four-Drive Capable Backplane Configuration Reference” on page 77
■ “Eight-Drive Capable Backplane Configuration Reference” on page 78
■ “Sixteen-Drive Capable Backplane Configuration Reference” on page 79
▼ Install a Hard Drive
Installing a hard drive into the SPARC Enterprise T5120 and T5220 servers is a
two-step process. You must first install a hard drive into the desired drive slot. Then
you must configure that drive to the server.
1. If necessary, remove the blank panel from the chassis.