FUJITSU SPARC T5120 - Manual (Page 189)

Servicing Boards and Components 163
FIGURE: Removing the Power Distribution Board From a SPARC Enterprise T5120 Server
8. Grasp the bus bar and pull the power distribution board/bus bar assembly to
the left, away from the paddle card.
9. Lift the power distribution board/bus bar assembly up and out of the system.
10. Place the power distribution board/bus bar assembly on an antistatic mat.
Related Information
■ “Install the Power Distribution Board” on page 163
▼ Install the Power Distribution Board
1. Lower the power distribution board/bus bar assembly into the chassis.
The power distribution board fits over a set of mushroom standoffs in the floor of
the chassis.
2. Slide the power distribution board/bus bar assembly to the right, until it plugs
into the paddle card.