FUJITSU SPARC T5120 - Manual (Page 53)

Detecting and Managing Faults 27
set /HOST/bootmode property=
value
[where property is state, config,
or script] bootmode [normal] [reset_nvram]
[config=configname] [bootscript=
string] Controls the host server OpenBoot
PROM firmware method of booting.
stop /SYS; start /SYS powercycle [-f]
The -f option forces an immediate
poweroff. Otherwise the command
attempts a graceful shutdown.
Performs a poweroff followed by
poweron
.
stop /SYS poweroff [-y] [-f]
• -y enables you to skip the
confirmation question.
• -f forces an immediate
shutdown.
Powers off the host server.
start /SYS poweron [-c]
• -c executes a console command
after completion of the poweron
command.
Powers on the host server.
set /SYS/P Sx
prepare_to_remove_action=
tru e
removefru /SYS/PS0 |
/SYS/PS1
Indicates if it is okay to perform a
hot-swap of a power supply. This
command does not perform any
action. But this command provides
a warning if the power supply
should not be removed because the
other power supply is not enabled.
reset /SYS reset [-y] [-c]
• -y enables you to skip the
confirmation question.
• -c executes a console command
after completion of the reset
command.
Generates a hardware reset on the
host server.
reset /SP resetsc [-y]
• -y enables you to skip the
confirmation question.
Reboots the service processor.
set /SYS keyswitch_state=
value
normal | standby | diag |
locked
setkeyswitch [-y] value
normal | standby | diag |
locked
• -y enables you to skip the
confirmation question when
setting the keyswitch to stby.
Sets the virtual keyswitch.
TABLE: Service-Related Commands (Continued)
ILOM Command ALOM CMT Command Description