beautypg.com

Keyswitch_state set to normal, Keyswitch_state set to diag, Diag_mode set to off – FUJITSU SPARC T5120 User Manual

Page 64: Diag_mode set to service, Related information, Keyswitch_state, Set to, Diag_mode

background image

38

SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009

Note –

When you change individual POST parameter values, the

keyswitch_state

value must be set to normal.

keyswitch_state

Set to normal

You put POST in its default mode by setting the virtual keyswitch property to
normal

. This enables the system to turn on and for POST to run.

keyswitch_state

Set to diag

You can apply preconfigured diagnostic settings to POST operations by setting the
virtual keyswitch property to diag.

diag_mode

Set to off

You can prevent POST from running by setting the diag_mode property to off.

diag_mode

Set to service

You force POST to run with a set of preconfigured values for diag_level and
diag_verbosity

by setting the diag_mode property to service.

Related Information

“ILOM Properties that Affect POST Behavior” on page 35

“Run POST in Maximum Mode” on page 39

“Clear POST-Detected Faults” on page 41

-> set /SYS keyswitch_state=normal

Set ‘keyswitch_state’ to ‘normal’

-> set /SYS keyswitch_state=diag

Set ‘keyswitch_state’ to ‘diag’

-> set /SYS diag_mode=off

Set ‘diag_mode’ to ‘off’

-> set /SYS diag_mode=service

Set ‘diag_mode’ to ‘service’

This manual is related to the following products: