beautypg.com

Related information, Display system components – FUJITSU SPARC T5120 User Manual

Page 76

background image

50

SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009

The database that contains the list of disabled components is referred to as the ASR
blacklist (asr-db).

In most cases, POST automatically disables a faulty component. After the cause of
the fault is repaired (FRU replacement, loose connector reseated, and so on), you
might need to remove the component from the ASR blacklist.

The following ASR commands enable you to view and add or remove components
(asrkeys) from the ASR blacklist. You run these commands from the ILOM ->
prompt.

Note –

The asrkeys vary from system to system, depending on how many cores

and memory are present. Use the show components command to see the asrkeys
on a given system.

After you enable or disable a component, you must reset (or power cycle) the system
for the component’s change of state to take effect.

Related Information

“Display System Components” on page 51

“Disable System Components” on page 52

“Enable System Components” on page 53

▼ Display System Components

The show components command displays the system components (asrkeys) and
reports their status.

Command

Description

show components

Displays system components and their
current state.

set

asrkey component_state=Enabled

Removes a component from the asr-db
blacklist, where asrkey is the component to
enable.

set

asrkey component_state=Disabled

Adds a component to the asr-db blacklist,
where asrkey is the component to disable.

This manual is related to the following products: