FUJITSU SPARC T5120 - Manual (Page 199)

Servicing Boards and Components 173
6. Tilt the paddle card away from the side of the chassis and lift the paddle card
up and out of the system.
7. Place the paddle card on an antistatic mat.
Related Information
■ “Install the Paddle Card” on page 173
▼ Install the Paddle Card
1. Lower the paddle card into the chassis.
FIGURE: Installing a Paddle Card (Illustrating Installation Into a SPARC Enterprise T5120
Server)
2. Slide the paddle card forward to plug it into the hard drive backplane.
3. Secure the paddle card with two No. 1 Phillips screws.
4. Install the fan power boards.
See “Install the Fan Power Board” on page 145 .
5. Install the power distribution board.
See “Install the Power Supply Backplane” on page 170 .
6. Install the motherboard assembly.
See “Install the Motherboard Assembly” on page 120 .
Related Information
■ “Remove the Paddle Card” on page 172