FUJITSU SPARC T5120 - Manual (Page 127)

Servicing Motherboard Components 101
3. (SPARC Enterprise T5120 server; 8 drive-capable) Disconnect and stow the hard
drive data cable.
a. Route the hard drive data cable over the fan module and along the air duct.
b. Plug the data cable into J6401 on the motherboard.
4. Open the air duct.
Disengage the rear of the air duct from the motherboard and rotate the air duct
forward.
5. Press in the edges of the air duct to disengage its pins from the chassis.
6. Set the air duct aside.
Related Information
■ “Install the Air Duct” on page 101
■ “Remove the Top Cover” on page 67
▼ Install the Air Duct
Caution – When the server is in operation, ensure that the air duct is correctly
installed to prevent the system from overheating.
1. Use the guide pins to align and install the air duct into the chassis.
2. Rotate the air duct down until it is seated on the motherboard.
3. (SPARC Enterprise T5120 server; 8 drive-capable) Reconnect the hard drive data
cable.
a. Route the hard drive data cable over the fan module and along the air duct.
b. Plug the data cable into J6401 on the motherboard.
4. Install the top cover.
See “Install the Top Cover” on page 175 for instructions.
Related Information
■ “Install the Top Cover” on page 175
■ “Remove the Air Duct” on page 100