Related information, Install a pcie or xaui card – FUJITSU SPARC T5120 User Manual
Page 133
Servicing Motherboard Components
107
■
SPARC Enterprise T5220: PCIe filler panels are located on the riser board
assembly. Press the filler panel into the riser board back panel from the rear.
Caution –
To ensure proper system cooling and EMI shielding, you must use the
appropriate PCIe filler panel for the server.
Related Information
■
“Install a PCIe or XAUI Card” on page 107
■
“Remove a PCIe/XAUI Riser” on page 102
■
“Install a PCIe/XAUI Riser” on page 104
▼ Install a PCIe or XAUI Card
1. Unpack the replacement PCIe or XAUI card and place it on an antistatic mat.
2. Locate the proper PCIe/XAUI slot for the card you are replacing.
3. If necessary, review the PCIe and XAUI card guidelines to plan your
installation.
See
“PCIe/XAUI Card Configuration Reference for SPARC Enterprise T5120
for additional information.
4. Remove the PCIe/XAUI riser board.
See
“Remove a PCIe/XAUI Riser” on page 102
5. Remove the PCI filler panel.
■
SPARC Enterprise T5120 servers
: PCIe filler panels are located in the
removable PCI cross beam. Press the filler panel in from the rear until it snaps
into place, as shown in the following figure.