FUJITSU SPARC T5120 - Manual (Page 95)

69
Servicing Hard Drives
These topics explain how to remove and install hard drives in SPARC Enterprise
T5120 and T5220 servers.
■ “Hard Drive Servicing Overview” on page 69
■ “Hard Drive LEDs” on page 70
■ “Remove a Hard Drive” on page 71
■ “Install a Hard Drive” on page 73
■ “Four-Drive Capable Backplane Configuration Reference” on page 77
■ “Eight-Drive Capable Backplane Configuration Reference” on page 78
■ “Sixteen-Drive Capable Backplane Configuration Reference” on page 79
Hard Drive Servicing Overview
Hard drives in SPARC Enterprise T5120 and T5220 servers are capable of being
removed and installed while the server is running. This feature, referred to as being
hot-pluggable, depends on how the hard drives are configured.
Note – SPARC Enterprise T5120 and T5220 servers support both traditional,
disk-based storage devices and flash SSDs, diskless storage devices based on
solid-state memory. The terms “hard drive” and “HDD” (hard disk drive) are used in
a generic sense to refer to both types of internal storage devices.
To hot-plug a drive, you must first take it offline. This prevent applications from
accessing it and removes software links to it.
There are two conditions that will prevent a drive from being hot-plugged:
■ The hard drive contains the sole image of the operating system -- that is, the
operating system is not mirrored on another drive.
■ The hard drive cannot be logically isolated from the server’s online operations.