FUJITSU SPARC T5120 - Manual (Page 54)

28 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
set /SYS/LOCATE value= value
[Fast_blink | Off]
setlocator value
[on | off]
Turns the Locator LED on the server
on or off.
(No ILOM equivalent.) showenvironment Displays the environmental status
of the host server. This information
includes system temperatures,
power supply, front panel LED,
hard drive, fan, voltage, and current
sensor status. See
“Display FRU
Information With the show
Command” on page 32
.
show faulty showfaults [-v] Displays current system faults. See
“Faults Displayed by show
faulty
” on page 29 .
(No ILOM equivalent.) showfru [-g lines] [-s | -d] [FRU]
• -g lines specifies the number of
lines to display before pausing
the output to the screen.
• -s displays static information
about system FRUs (defaults to
all FRUs, unless one is specified).
• -d displays dynamic information
about system FRUs (defaults to
all FRUs, unless one is specified).
See
“Display FRU Information
With the show Command” on
page 32
.
Displays information about the
FRUs in the server.
show /SYS keyswitch_state showkeyswitch Displays the status of the virtual
keyswitch.
show /SYS/LOCATE showlocator Displays the current state of the
Locator LED as either on or off.
show /SP/logs/event/list showlogs [-b lines | -e lines |
-v] [-g lines] [-p
logtype[r|p]] ]
Displays the history of all events
logged in the service processor
event buffers (in RAM or the
persistent buffers).
show /HOST showplatform [-v] Displays information about the
operating state of the host system,
the system serial number, and
whether the hardware is providing
service.
TABLE: Service-Related Commands (Continued)
ILOM Command ALOM CMT Command Description