ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 356)

Maintenance and Troubleshooting 10-35
Problem Time on the monitor clock is incorrect.
Possible
Causes
Monitor clock may be a faulty.
Monitor time zone difference for the PC clock may not
have been set correctly when the monitor was activated.
Possible
Solutions
Verify the time on the PC clock and correct if
necessary.
Reactivate the monitor to enable the clock.
Verify the time zone setting of the monitor. Correct and
reactivate if necessary.
Collect the data from the monitor and replace monitor if
defective.
Problem You receive a Device Time Out message in Qstart.
Possible
Cause
Communications may be marginal.
Modem may be defective.
Possible
Solutions
Re-attempt communication with monitor. Verify signal
strength. Check a Qstart data collect log or check the
Status in Qstart. If the signal strength indicated is less
than -95 (for example: -99), consider re-orienting the
antenna and/or installing the antenna in a pedestal
above ground.
Contact your regional ADS representative.
Replace the monitor if defective.