ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 188)

6-1
C H A P T E R 6
Configuration and Activation
After installing the ADS ® TRITON+ ™ flow monitor and sensors
and establishing communications, it is necessary to configure and
activate the monitor to begin taking flow measurements and
recording data at the monitor location. This chapter contains
general instructions on the following activities concerning monitor
configuration and activation:
 Starting and configuring Qstart ™
 Creating and configuring a monitor location
 Configuring the monitoring point installation (pipe) table
(including setting Gain)
 Selecting and editing devices (usually attached sensors)
 Activating the monitor
This chapter also includes the procedures for running diagnostics
and performing confirmations on the sensors, collecting data from
the monitor, and upgrading the firmware (embedded software) in
the monitor using the ADS Qstart software. You can also consult
the Qstart online help within the application.