ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 350)

Maintenance and Troubleshooting 10-29
Blue fuse removed from the regulator board
14. Carefully insert the new, replacement fuse(s) into the
corresponding holes in the dome without bending the fuse
filaments. Verify that the color strip on the fuse matches the
color on the regulator board adjacent to the holes. Make sure
the fuse(s) is seated firmly and securely.
15. Realign and reseat the dome against the monitor top, and
replace the thumb nut to secure the dome to the top.
16. (applicable only to battery-powered monitors) Reconnect the
battery cable to the cable exiting from the hole in the top/dome
assembly.
17. Coil the excess cabling around the inner wall of the canister
(when applicable), and carefully lower the top/dome assembly
back onto the canister. Keeping the proper orientation between
the canister and the top is critical to maintaining the watertight
and airtight seal on the monitor. Once the top has been torqued
down after manufacture, the sealing gasket develops a memory
profile of the canister lip. Reassembling the two pieces in the
same orientation as before helps the gasket mate correctly with
the canister lip.
Note: Be careful to avoid pinching the battery cable
(when applicable) between the canister sealing lip and the
gasket on the monitor top during reassembly. The cable