HP 750 - Manual (Page 91)

Reinstall the trailing cable following the previous steps in the reverse sequence. After
reinstalling, two adjustments are required to ensure correct functionality:
ANGULAR ADJUSTMENT
1 Move the carriage to the maximum rightĆend position (interacting with the YĆaxis motor
holder).
2 Release the trailingĆcable clip on the carriage, and adjust the length of the trailing cable
to avoid interaction with the YĆaxis motor holder. The minimum distance between the
trailing cable and the holder should be 0.5 cm.
1 Loosen the screw that attaches the lower trailingĆcable holder to the chassis.
2 Perform the angular adjustment to align the trailing cable with the slider rods and belt.
LENGTH ADJUSTMENT
6-39 Removal and Replacement C4705-90000
Reinstalling the Trailing Cable