HP 750 - Manual (Page 57)

1 Ensure that the plotter is switched off
and that the power cord and interface
cable(s) are not connected to it.
2 At the back of the plotter, ensure that
the two small wire clamps of the parallel
port are positioned vertically.
No interface
cables connected.
Power inlet: cord
not connected
3 Remove the screws that attach the cover
to the electronics enclosure.
D/A1Ćsize plotters have six screws.
E/A0Ćsize plotters have eight screws.
or Flat Tx 10
4 Gently lift up the cover to an angle of 45_.
6-5 Removal and Replacement C4705-90000
Repair Procedures
Removing the ElectronicsĆEnclosure Cover