HP 750 User Manual
Page 78
9 Remove the two screws that secure the
media motor to the mediaĆmotor mount.
10 Pull the media motor towards the rear of
the plotter.
11 Disconnect the flat encoder cable from the
motor, and lift the motor clear of the
plotter.
Reinstalling: The worm pinion and
driveĆroller gear mesh slightlyduring use.
Do not install a new motor and an old
gear, or vice versa: install the gear that
comes with the motor. Applythe grease
that comes with the new motor onto the
worm pinion and driveĆroller gear.
Calibration: After reassembling the
plotter, perform the accuracycalibration
(Details ' page 7Ć6).
Tx 15
6-26
Removal and Replacement
C4705-90000