HP 750 - Manual (Page 166)

8-48 Troubleshooting C4705-90000
27. Cutter
The purpose of this test is to verify the operation of the cutter.
The cutter test performs these two tests:
D Single cut test.
D Continuous cut test.
Perform the cutter test as follows:
Load media before performing this test.
1 In the Service Tests submenu, scroll to 27 Cutter" and press Enter.
SERVICE TESTS
27 Cutter
2 The Single Cut / Continuous Cut" message is displayed on the frontĆpanel.
3 Press the Up Arrow button to perform the single cut test.
If you want to perform the continuous cut test, then go to step 5.
4 The Cutter Offset = # / Up, Down, Enter (Cut)?" message is displayed on the
frontĆpanel. Use the Up and Down Arrow buttons to increase or decrease the offset
value (#) of the cutter. Press Enter when you want to make the single cut.
5 If you want to perform the continuous cut test, then at step 3 press the Down Arrow
button.
6 The Press Enter to Exit" message is displayed on the frontĆpanel as the plotter performs
the test.
The plotter continuously uses the cutter to cut the media until you press Enter.