HP 750 User Manual
Page 219
C4705-90000
10-21
Product History and Service Notes
7 Grasp the carriage rear preload bushing and move the carriage to the right side and free
of the slider rods.
8 Separate the rear bushing and preload spring from the carriage and carefully remove the
carriage and main drive belt from the plotter.
9 Remove the drive belt from the carriage.
10 Install the new pen carriage following the above instructions in the reverse order.
Administrative Information
Classification:
Modification Recommended
Standards:
1 Hour Labor
Action Category:
On Failure
Location Category:
OnĆSite
Service Inventory:
N/A
Used Parts:
Returned to SME/HP Grenoble
HP Responsible Until: 15 December 1997
AuthorEntity:
HV/F900