HP 750 - Manual (Page 69)

Reassembling: When replacing screws on any plastic part, always begin
by gently twisting the screw in an anticlockwise direction with your hand,
until the screw finds the thread path and clicks, and then twisting the screw
in clockwise with your hand, before using a screwdriver. This is to avoid
crossĆthreading and damaging the thread. Do not overĆtighten the screws.
1 Remove the window ' page 6Ć13.
2 Remove the center cover ' page 6Ć14.
3 Remove the two screws on the right trim.
C F U T I O N
Reassembling: Note that the upper and
lower grooves of the endcover engage on the
front panel.
4 Remove the three recessed screws from
the right side of the right endcover.
5 Maintaining an even pressure on the top
and bottom of the endcover, pull it to the
right, away from the plotter.
Tx 15
Tx 15
6-17 Removal and Replacement C4705-90000
Removing the Right Endcover