HP 750 - Manual (Page 100)

1 Remove the window ' page 6Ć13.
2 Remove the center cover ' page 6Ć14.
3 Remove the left endcover ' page 6Ć16.
4 Remove the right endcover ' page 6Ć17.
5 Remove the bail assembly ' page 6Ć45.
6 Remove the encoder strip ' page 6Ć27.
7 Remove the carriage (YĆaxis) motor
' page 6Ć16.
8 Remove the YĆaxismotor holder
' page 6Ć32.
9 Remove the cutter ' page 6Ć33.
10 Remove carriage ' page 6Ć34.
11 Remove the primer ' page 6Ć41.
12 Remove the service station ' page 6Ć42.
13 Remove the clutch retaining ring that
secures the overdrive clutch to the
overdrive roller.
14 Remove the clutch and washers
15 Remove the overdrive cluster gear from
the plotter.
16 Remove the screw from the top of each of
the overdrive support mounts.
Tx 20
17 Pull the right side of the overdrive
assembly up.
18 Rotate the top of the assembly towards
the back of the plotter and pull the
assembly to the right, out from the left
sideĆplate.
Be careful not to lose the bushing on the left side of the overdrive roller.
Reassembling: Ensure that you install the
clutch as shown in the figure. If you install
it in reverse, it will cause inkĆsmearing and
paper jam problems.
Cluster gear
6-48 Removal and Replacement C4705-90000
Removing the Overdrive Assembly