HP 30 HP30 - Manual (Page 78)

Chapter 5 - Parameter List
5-18
Keypad Display Setting Range
Code Description
LCD 7-Segment LCD 7-Segment
Units
Factory
Default
Adj.
During
Run
Page
EXT-56 Torque Detection Level TD Level 50 0 to 150 [%] 0.1 100 [%] Yes
EXT-57
Torque Detection
Bandwidth
TD Band 51 0 to 10 [%] 0.1 5 [%] Yes
EXT-99 Return Code
Not
displayed
99 Not available
[PROG/ENT]
or
[SHIFT/ESC]
- 1 Yes
5.6 Communication Group [COM]
COM group appears only when the corresponding Option Boards are installed. Please refer to the option manual for detail.
Keypad Display Setting Range
Code Description
LCD 7-Segment LCD 7-Segment
Units
Factory
Default
Adj.
During
Run
Page
COM-00 Jump to Desired Code # Jump code Not displayed 0 to 99 Not available 1 1 Yes
None 0
Device Net 1
Synchro 2
PLC-GF 3
Profibus-DP 4
Digital-In 5
RS485 6
COM-01 Option Board Type Opt B/D 01
Modbus-RTU 7
- None Yes
None 0
Command 1
Freq 2
COM-02 Option Mode Opt Mode 02
Cmd + Freq 3
- None No
COM-03 Option Version
Opt Version 03 - - - - No
8 Bit Bin 0
8 BCD 1% 1
8 BCD 1Hz 2
12 Bit Bin 3
12 BCD 0.1% 4
12 BCD 0.1Hz 5
COM-04
Binary Option Input
Selection
D-In Mode 04
12 BCD 1Hz 6
- 8 Bit Bin No
COM-05 Binary Input Filter Value Digital Ftr 05 2-50 1 15 Yes
COM-10 Device Net ID MAC ID 10 0-63 1 0 Yes
125 kbps 0
250 kbps 1 COM-11
Device Net
Communication Speed
Baud Rate 11
500 kbps 2
- 125 kbps Yes
20 0
21 1 COM-12 Device Net Output
Instance
Out Instance 12
100 2
- 20 No