HP 30 HP30 - Manual (Page 69)

Chapter 5 - Parameter List
5-9
Keypad Display Setting Range
Code Description
LCD 7-Segment LCD 7-Segment
Units
Factory
Default
Adj.
During
Run
Page
FU2-72 Power On Display
PowerOn disp 72 0 to 12 1 0 Yes 6-2
Voltage 0
FU2-73 User Display Selection User disp 73
Watt 1
- Voltage Yes 6-2
FU2-74
Gain for Motor Speed
Display
RPM factor 74 1 to 1000 [%] 1 100 [%] Yes 6-2
None 0
Int. DB-R 1 FU2-75
DB (Dynamic Braking)
Resistor Mode Selection
DB mode 75
Ext. DB-R 2
- Int. DB-R Yes 6-2
FU2-76 23
Duty of Dynamic Braking
Resistor
DB %ED 76 0 to 30 [%] 1 10 [%] Yes 6-2
FU2-79 Software Version S/W version 79 Ver 2.0 - - - 6-2
FU2-81 24 2 nd Acceleration Time 2nd Acc time 81 0 to 6000 [sec] 0.1 5.0 [sec] Yes
FU2-82 2 nd Deceleration Time 2nd Dec time 82 0 to 6000 [sec] 0.1 10.0 [sec] Yes
FU2-83 2 nd Base Frequency 2nd BaseFreq 83 30 to FU1-20 0.01 60.00 [Hz] No
Linear 0
Square 1 FU2-84 2 nd V/F Pattern 2nd V/F 84
User V/F 2
- Linear No
FU2-85 2 nd Forward Torque Boost 2nd F-boost 85 0 to 15 [%] 0.1 2.0 [%] No
FU2-86
2 nd Reverse Torque
Boost
2nd R-boost 86 0 to 15 [%] 0.1 2.0 [%] No
FU2-87 2 nd Stall Prevention Level
2nd Stall 87 30 to 150 [%] 1 150[ %] No
FU2-88
2 nd Electronic Thermal
Level for 1 minute
2nd ETH 1min 88 FU2-89 to 200 [%] 1 150 [%] Yes
FU2-89
2 nd Electronic Thermal
Level for continuous
2nd ETH cont 89
50 to FU2-88
(Maximum 150%)
1 100 [%] Yes
FU2-90 2 nd Rated Motor Current
2nd R-Curr 90 1 to 200 [A] 0.1 3.6 [A] No
6-2
No 0
FU2-91
Read Parameters into
Keypad from Inverter
Para. Read 91
Yes 1
- No No
No 0
FU2-92
Write Parameters to
Inverter from Keypad
Para. Write 92
Yes 1
- No No
6-2
No 0
All Groups 1
DRV 2
FU1 3
FU2 4
I/O 5
EXT 6
COM 7
FU2-93 Initialize Parameters Para. Init 93
APP 8
- No No 6-2
23 Code FU2-76 appears only when FU2-75 is set to ‘Ext. DB-R’.
24 Code FU2-81 through FU2-90 appear only when one of I/O-12 ~ I/O-14 is set to ‘2nd function’.