Canon EOS-1D X Mark II DSLR Camera (Body Only) - Manual (Page 42)

42
1
Connect the charger to a power outlet.
Connect the power cord to the
charger and insert the power plug into
a power outlet.
When no battery is attached, all the
indicator lamps will be off.
2
Remove the protective cover.
As shown in the illustration, detach
the charger’s protective cover
(provided) and the battery’s protective
cover (provided).
3
Recharge the battery.
Slide the battery into the charger’s
slot as shown by the arrow, and make
sure it is securely attached.
You can attach the battery to either
slot or slot .
X Charging will start and the charge
lamp will blink or light up in green.
X When all three charge lamps light
up in green
(50%/80%/100%) , the
charging is complete.
To recharge a fully exhausted battery at room temperature (23 °C/
73 °F), it takes approx. 2 hr. 50 min. for the LP-E19 and approx. 2
hr. 20 min. for the LP-E4N/LP-E4.
(The battery recharge time varies
widely depending on the ambient temperature and the battery’s
remaining capacity.)
For safety reasons, recharging in low temperatures (5°C - 10°C /
41°F - 50°F) will take a longer time (up to approx. 5 hours only when
charging Battery Pack LP-E19).
Charging the Battery
If two batteries are attached to the charger, the battery attached first will
be charged first, then the other battery will be charged.
Provided Battery Charger LC-E19 can also charge Battery Pack LP-E4N/LP-E4.