Canon EOS-1D X Mark II DSLR Camera (Body Only) - Manual (Page 221)

221
Convenient when you want to continue geotagging the image with the
location information even when the satellite signal is disrupted when
you move from outdoors to indoors, etc. With [
Unlimited ] selected, the
images will be geotagged with the location information last acquired
until the updated location information is acquired. With “Time” selected,
if the location information acquisition is disrupted, images will continue to
be geotagged with the last-acquired location information until the set time.
1
Check the [GPS] setting.
Check that [ GPS ] is set to [ Mode 1 ]
or [ Mode 2 ].
2
Select [GPS Logger].
3
Set [Log GPS position] to
[Enable].
Select [ Log GPS position ], then
press < 0 >.
Select [ Enable ], then press < 0 >.
4
Select [Position data retention].
5
Set the time.
Setting a Time Limit for Geotagging the
Last Acquired Location Information
The location information may not be geotagged immediately after you set
the power switch to <
1 > or if you shoot right after auto power off.
Even when [ Log GPS position ] has been set to [ Disable ] ([ Position
data retention ] is not set), the location information will continue to be
geotagged to the image for approx. 10 min. after the disruption of the
location information acquisition.
See papes 223-226 for GPS logging function. Note that the location
information will not be appended to the images when you download the
logging data to a computer or transfer them to a card.
The camera will retain the location information last acquired even after you
set the power switch to <
2 > or replace the battery.