Brother ADS-2400N - Manual (Page 186)

Scan Using the Control Panel
170
7
D
In the Margin Settings, enter -3 to 3 to add or remove a specific margin at the edge of the image.
E
Set Auto Deskew
1
to Auto to correct the skew (less than 0.36 in. (9 mm) from the center of the
document to the edge) of the scanned data.
F
Set Skip Blank Page
1
to On to remove blank pages of the document from the scanned data.
G
Select -5 to 5 from the drop-down list to adjust the Skip Blank Page sensitivity.
H
Select Continuous Scan to On to continue scanning.
I
Set the Passive Mode option to off or on depending on your FTP server and network firewall configuration.
The default setting is On. In most cases this setting does not need to be changed.
J
Change the Port Number setting used to access the FTP server. The default for this setting is port 21.
In most cases this setting does not need to be changed.
K
Click Submit.
1 Depending upon the condition of the original document, this function may not work properly.
NOTE
Using the following characters: ?, /, \, ", :, <, >, | or * may cause a sending error.