Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 74)

LSI Corporation
- 74 -
StorCLI Reference Manual
January 2013
Appendix B: MegaCLI Commands to StorCLI Command Conversion
Show the security key for secured
physical drives MegaCli -GetKeyID
[-PhysDrv[E0:S0]] -aN storcli /cx/ex/sx show securitykey
keyid
Start, stop, and show the progress of
a secure erase operation MegaCli -SecureErase Start[
Simple|
[Normal [ |ErasePattern
ErasePatternA|ErasePattern
ErasePatternA ErasePattern
ErasePatternB]]|[Thorough [
|ErasePattern
ErasePatternA|ErasePattern
ErasePatternA ErasePattern
ErasePatternB]]]
| Stop| ShowProg| ProgDsply
[-PhysDrv [E0:S0,E1:S1,...] |
-Lx|-L0,1,2|-LALL]
-aN|-a0,1,2|-aALL
storcli /cx[/ex]/sx start erase
[simple| normal| thorough]
[erasepatternA=<val>]\n[erasepatternB=<
val>]
Examples:
storcli /cx/ex/sx start erase simple
storcli /cx/ex/sx start erase normal
erasepatterna=10101010
storcli /cx/ex/sx start erase thorough
erasepatterna=10101010
erasepatternb=10101111
storcli /cx/ex/sx stop erase
Enable/disable the direct physical
drive mapping mode.
Show the current state of the direct
physical drive mapping.
MegaCLI DirectPdMapping
-Enbl|-Dsbl|-Dsply
-aN|-a0,1,2|-Aall storcli /cx set directpdmapping=off>
storcli /cx show directpdmapping
Table 21 Enclosure Commands
Description MegaCLI Command StorCLI Command
Show enclosure information. MegaCli –EncInfo
-aN|-a0,1,2|-aALL storcli /cx/ex show
storcli /cx/ex show all
Show enclosure status. MegaCli –EncStatus
-aN|-a0,1,2|-aALL storcli /cx/ex show status
Table 22 PHY Commands
Description MegaCLI Command StorCLI Command
Show PHY information. MegaCli –PHYInfo -phyM
-aN|-a0,1,2|-aALL storcli /cx/px(x|all) show
storcli /cx/px(x|all) show all
Set PHY link speed. MegaCLI PhySetLinkSpeed -phyM
-speed -aN|-a0,1,2|-aALL storcli /cx/px(x|all) set
linkspeed=0(auto)|1.5|3|6|12
Show the PHY error counters. Megacli PhyErrorCounters -An storcli /cx/px(x|all) show
storcli /cx/px(x|all) show all
Table 20 Physical Drive Commands (Continued)
Description MegaCLI Command StorCLI Command