Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 22)

LSI Corporation
- 22 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Drive Commands
4.2.7 Controller Cache Command
The following command flushes the controller cache:
storcli /cx flush|flushcache
This command flushes the controller cache.
Input example:
storcli /c0 flushcache
4.3 Drive Commands
This section describes the drive commands, which provide information and perform actions related to physical drives.
The following table describes frequently used virtual drive commands.
4.3.1 Drive Show Commands
The Storage Command Line Tool supports the following drive show commands:
storcli /cx[/ex]/sx show
storcli /cx[/eall]/sall show
storcli /cx[/ex]/sx|sall show all
The detailed description for each command follows.
storcli /cx[/ex]/sx show
This command shows the summary of the physical drive for a specified slot in the controller.
Input example:
storcli /c0/e0/s4,5 show
storcli /cx[/eall]/sall show
This command shows the summary information for all the enclosures and physical drives connected to the controller.
Input example:
storcli /c0/eall/sall show
Table 10 Physical Drives Commands Quick Reference Table
Commands Value Range Description
set missing : Sets the drive status as missing.
good : Sets the drive status to unconfigured good.
offline : Sets the drive status to offline.
online : Sets the drive status to online.
Sets physical drive properties.
show all : shows all properties of the physical drive.
See Section 4.3.1 , Drive Show Commands .
Shows virtual drive information.
NOTE If enclosures are used to connect physical drives to the controller, specify the enclosure ID in the
command. If no enclosures are used, you must specify the controller ID and slot ID.