Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 11)

LSI Corporation
- 11 -
StorCLI Reference Manual
January 2013
Chapter 4: Working with the Storage Command Line Tool
Controller Commands
4.2 Controller Commands
Controller commands provide information and perform actions related to the specified controller, such as the /c0
controller. The Storage Command Line Tool supports the controller commands described in this section.
4.2.1 Show and Set Controller Properties Commands
This section provides command information to show and set controller properties.
The generalized syntax for show controller properties command is as follows.
storcli /cx show
This command shows the current value of the specified property on the specified controller.
General example output:
Status Code = 0
Status = Success
Description = None
Controller: 0
Property_name = Property_value
You can show the following properties using the storcli /cx show <property1>|<property2>
command.
storcli /cx show abortcconerror
storcli /cx show activityforlocate
storcli /cx show alarm
storcli /cx show backplane
storcli /cx show batterywarning
storcli /cx show bgirate
storcli /cx show bootwithpinnedcache
storcli /cx show cachebypass
storcli /cx show cacheflushint
storcli /cx show ccrate
storcli /cx show clusterenable
storcli /cx show coercion
storcli /cx show consistencycheck|cc
storcli /cx show copyback
storcli /cx show directpdmapping
storcli /cx show dimmerswitch|ds
Table 3 Controller Commands Quick Reference Table
Commands Value Range Description
show <properties> See Table 4 Shows specific controller properties.
set <properties> See Table 4 Sets controller properties.
show all : Shows all properties of the virtual drive.
freespace : Shows the freespace in the controller.
See Section 4.2.2 , Controller Show Commands .
Shows physical drive information.
NOTE You cannot set multiple properties with a single command.